Subscriptions
Get E-mail on new products
HOW DO YOU KNOW ABOUT SKIRTING ?
The skirting is very easy to overlook in the home decoration part, but it is a very important part of the following will introduce the role of the baseboard and baseboard installation process.
skirting installation process:
1, drilling: drilling to observe the good water and electricity before the wiring to prevent mistakes. The hole can not be too large, or the baseboard is difficult to stick to the wall. Use special tools to drill holes in the wall. The common length of the baseboard is 2m. In order to fix the skirting line more firmly, the interval between the holes should be about 40cm, the interval should be smaller. Put the small pieces of wood into just the hole. The nail on the fixed baseboard is nailed to the wood, nailed directly to the wall, the nail is easy to loosen.
Note: As the hydropower project pipe buried on the wall, the switch socket is just below the location of the pipe, when the hole to be considered a good location to avoid damage.
2, fixed: fixed baseboard before the wall to be flat, clean up, or skirting line installed up, can not be completely close to the wall, will leave ugly gap. Look at the location of the drill, and then fix the nail on the baseboard. Fixed to pay attention to the baseboard and the wall is close, nails should not be completely into the baseboard, can not see.
Note: Whether it is polymer, MDF, wood material baseboard, have the characteristics of thermal expansion and contraction, so by the corner of the base line should also be the same as the floor, leaving about 1cm expansion joints.
3, corner processing: corner, where the base line intersection, the edge of the baseboard to the 45-degree angle of the cut, so that the interface will not leave ugly marks. Will be cut off the base line to be fixed.
Note: the corner of the baseboard must be cut through the 45-degree angle before splicing, installation, or will affect the appearance.
4, the installation points: fixed baseboard nails to use a special screw nails, such a fixed effect is better, not easy to loose. We should pay attention to whether the manufacturers cut corners. The baseboard was originally intended to cover the floor of the expansion joints, so that the ground more beautiful. So the edge of the base line to use the edge of the plane shaved. The baseboard to be completely close to the wall, leaving no gap, only more beautiful, especially the corner. The flatness of the wall should be tested before installation.
The role of the baseboard:
1, the ground decoration materials and wall of the mouth, floor tiles or wood flooring and the combination of the wall is not very good, to rely on the base line to achieve smooth;
2, to prevent the health of the wall when the pollution
3, the base line with the floor match, to achieve a beautiful effect